Wollongong PathWay ODI Installation
1
Run the Intel Installation Program from Disk 1, Installation Disk.
2
Choose Wollongong PathWay Access from the Select Network
Operating System screen.
3
Follow the prompts to complete the Intel segment of the
installation.
4
Install PathWay Access for DOS Kernel and Drivers programs
according to the instructions in the PathWay Access for DOS
manual. Before rebooting the PC, perform the following steps.
5
Run the MS-DOS batch file DCOMPVLM.BAT from the
Network Drivers Disk, as follows:
DCOMPVLM PATHWAY
DCOMPVLM.BAT will decompress and copy all required files
from the Intel Network Drivers Disk to the PATHWAY directory
on your hard disk or boot disk. (The files are LSL.COM,
M16AODI.COM, IPXODI.COM, VLM.EXE, M16ACFG.EXE,
and NET.CFG.)
6
Change to the PATHWAY directory and load the software in the
following order:
M16ACFG
LSL
M16AODI
IPXODI (only if using Novell NetWare)
VLM (only if using Novell NetWare)
7
Load the Wollongong file ODI.EXE.
8
Continue with the instructions in the PathWay Access for DOS
manual.
9
Reboot the PC.
Software Installation
55