Intel EtherExpress PRO/100 User Manual page 109

• DoubleSpace defaults to G or H as lastdrive, thus H: or I: will be
the login drive when using DoubleSpace. The lastdrive com-
mand in CONFIG.SYS seems to be overruled by DoubleSpace
lastdrive.
Sample NET.CFG when using VLMs:
NETWARE DOS REQUESTER
FIRST NETWORK DRIVE = F
The following error occurred while loading protocol 0, error 58:...
This usually occurs when you have installed the IPX support stack in
Windows for Workgroups and ODI, and later decided to switch to
NDIS2 and not use IPX as another stack.
Windows for Workgroups sometimes will forget to remove the
NWLINK.386 and NWBLINK.386 from the transport line in the
[386enh] section of your C:\WINDOWS\SYSTEM.INI file. Fix this
by making sure that the transport line in that section reads:
[386ENH]
TRANSPORT=NETBEUI.386
Error 7323 or 3658:, The IFSHLP.SYS driver is not installed, or
Windows Network was not started, check your configuration.
Make sure the IFSHLP.SYS is installed in you CONFIG.SYS file and
that this file exists in the C:\WINDOWS directory. See the sample
CONFIG.SYS for proper syntax.
Error 7733: The protocol manager has reported an incomplete
binding.
Make sure to check your \WINDOWS\PROTOCOL.INI to have
proper bindings. The MS$NDISHLP and NETBEUI sections should
have a BINDINGS=M16AMAC. Chances are, the binding statement
is wrong. See the sample PROTOCOL.INI file.
Windows for Workgroups works the first time I boot the machine, but
after a warm boot, it fails to see other machines.
Turn off the power to shut down the machine and do a COLD BOOT.
See if this fixes the problem.
Troubleshooting
109