Intel EtherExpress PRO/100 User Manual page 69

NETM16A.INF
M16A.SYS
There are user-configurable parameters to the M16A.SYS driver
which can be modified using the Network Control Panel built into
Windows 95. This applet queries the user for parameter selections and
then sets the corresponding parameters in the registry. The user-
configurable parameters are as follows:
Parameter
CABLE TYPE
DIRECT ENABLE
EARLY TRANSMIT
FULL DUPLEX
LINE SPEED
LINK INTEGRITY
MODE
NETWORKADDRESS
TRANSMITBUFFERSIZE 7168
The network node address can be modified by specifying a value for
'NetworkAddress' such as '00A0C9112233'. If the user does NOT
specify a 'NetworkAddress' then the M16A.SYS driver uses the
network node address contained in the PRO/100 PC Card Information
Structure.
There are parameters in the Windows 95 registry which specify the
configuration of the PRO/100 PC Card hardware to the M16A.SYS
driver. Many of these parameters correspond directly to the user-
configurable parameters. These parameters are found in the registry at
the following location:
HKEY_LOCAL_MACHINE\SYSTEM\CURRENTCONTROLSET\SERVICES\CLASS\NET\000X
Intel installation file for Windows 95
Intel NDIS 3 driver for Windows 95
Default Valid Values
AUTO AUTO
TWISTED PAIR 10BT 1
OFF OFF, ON
ON OFF
ON
OFF OFF
ON
AUTO AUTO DETECT
10MBPS
100MBPS
ON OFF
ON
I/O I/O
MEMORY MAPPED
1024-29696
Configuration Reference
Registry Value
0
0
0
1
0
1
0
1
2
0
1
0
1
1024-29696
69