Note
M16ACFG.EXE is not used under Microsoft Windows 95,
Windows NT, or IBM OS/2.
Memory Exclusion (Windows 3.x)
When using a memory manager, you must exclude a 4K memory
range between C000 to EF00 for the use of the PRO/100 PC Card. For
example:
device=c:\dos\himem.sys
device=c:\dos\emm386.exe noems x=D200-D2FF
This example excludes 4K of the D200 segment for use by the PRO/
100 when using the default memory address D200. If the PRO/100 is
configured for a memory address other than the default, be sure to
exclude a corresponding 4K memory address range.
Sample Configuration Files for Selected Network
Operating Systems (Windows 3.x)
The following sample configuration files show default parameters for
some network operating systems run under Windows 3.x. This
information is designed to supplement the information provided in
Chapter 2. Software Installation.
Artisoft LANtastic/AI 6.0 (Windows 3.x)
Note
If you are using DOS multi-menu CONFIG.SYS, the three
LANtastic-related lines in the CONFIG.SYS will be located in
a COMMON section at the end of your CONFIG.SYS. You
will have to manually move those lines into the proper
menuitem section of your CONFIG.SYS. The same is true
for the line call c:\lantasti\startnet.bat in your
AUTOEXEC.BAT file.
Sample CONFIG.SYS
DEVICE=C:\DOS\HIMEM.SYS
REM INTEL PRO/100 ADAPTER — DO NOT CHANGE LINES BELOW
DEVICE=C:\DOS\EMM386.EXE NOEMS X=D200-D2FF
REM DEVICE=C:\DOS\EMM386.EXE NOEMS
REM INTEL PRO/100 — DO NOT CHANGE LINES ABOVE
Configuration Reference
61