Table of Contents
Advertisement
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch. Click
Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 103 Advanced Application > Spanning Tree Protocol > Configuration
The following table describes the labels in this screen.
Table 62 Advanced Application > Spanning Tree Protocol > Configuration
LABEL
Spanning Tree
Mode
Apply
Cancel
13.4 Configure Rapid Spanning Tree Protocol
Use this screen to configure RSTP settings, see
Click RSTP in the Advanced Application > Spanning Tree Protocol screen.
Chapter 13 Spanning Tree Protocol
DESCRIPTION
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree or Multiple Spanning Tree. See
background information on STP.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XS1930 Series User's Guide
140
Section 13.1 on page 137
Section 13.1 on page 137
for
for more information on RSTP.
Advertisement
Table of Contents
Troubleshooting
