Arp Static - HP 6125G Command Reference Manual

Use undo arp max-learning-num to restore the default.
By default, a Layer 2 interface does not limit the number of dynamic ARP entries. The maximum number
of dynamic ARP entries that a Layer 3 interface can learn is 4096.
When the number argument is set to 0, the interface is disabled from learning dynamic ARP entries.
Examples
# Specify VLAN-interface 40 to learn up to 50 dynamic ARP entries.
<Sysname> system-view
[Sysname] interface vlan-interface 40
[Sysname-Vlan-interface40] arp max-learning-num 50
# Specify GigabitEthernet 1/0/1 to learn up to 100 dynamic ARP entries.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] arp max-learning-num 100
# Specify Layer 2 aggregate interface bridge-aggregation 1 to learn up to 100 dynamic ARP entries.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] arp max-learning-num 100

arp static

Syntax
arp static ip-address mac-address [ vlan-id interface-type interface-number ] [ vpn-instance
vpn-instance-name ]
undo arp ip-address [ vpn-instance-name ]
View
System view
Default level
2: System level
Parameters
ip-address: Specifies the IP address in an ARP entry.
mac-address: Specifies the MAC address in an ARP entry, in the format H-H-H.
vlan-id: Specifies the ID of a VLAN to which a static ARP entry belongs, in the range of 1 to 4094.
interface-type interface-number: Specifies the interface type and interface number.
vpn-instance vpn-instance-name: Specifies the MPLS L3 VPN for a static ARP entry. The
vpn-instance-name argument is a case-sensitive string of 1 to 31 characters. Without this option, the static
ARP entry belongs to the public network.
Description
Use arp static to configure a static ARP entry in the ARP mapping table.
Use undo arp to remove an ARP entry.
2