Ipv6 Nd Ra Halt - HP 6125G Command Reference Manual

Default level
2: System level
Parameters
value: Specifies the neighbor reachable time in milliseconds, in the range of 1 to 3600000.
Description
Use ipv6 nd nud reachable-time to configure the neighbor reachable time on an interface. This time
value serves as not only the neighbor reachable time on the local interface, but also the value of the
Reachable Time field in RA messages sent by the local interface.
Use undo ipv6 nd nud reachable-time to restore the default.
By default, the neighbor reachable time on the local interface is 30000 milliseconds and the value of the
Reachable Time field in RA messages is 0, so that the reachable time is determined by the receiving
device.
Related commands: display ipv6 interface.
Examples
# Set the neighbor reachable time on VLAN-interface 100 to 10,000 milliseconds.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd nud reachable-time 10000

ipv6 nd ra halt

Syntax
ipv6 nd ra halt
undo ipv6 nd ra halt
View
Interface view
Default level
2: System level
Parameters
None
Description
Use ipv6 nd ra halt to enable RA message suppression.
Use undo ipv6 nd ra halt to disable RA message suppression.
By default, RA messages are suppressed.
Examples
# Suppress RA messages on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ra halt
131