HP 6125G Command Reference Manual page 163

Tunnel0 current state: UP
Line protocol current state: UP
Description: Tunnel0 Interface
The Maximum Transmit Unit is 1476
Internet Address is 58.0.0.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 20.0.0.2 (Vlan-interface2000), destination 20.0.0.1
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IP
Last clearing of counters:
Last 300 seconds input:
Last 300 seconds output:
1847 packets input,
0 input error
5572 packets output,
0 output error
Table 38 Command output
Field
Tunnel0 current state
Line protocol current state
Description
Maximum Transmit Unit
Internet Address
Encapsulation is TUNNEL
service-loopback-group ID
Tunnel source
destination
Tunnel bandwidth
Never
0 bytes/sec, 0 packets/sec
28 bytes/sec, 0 packets/sec
136451 bytes
428860 bytes
Description
Physical state of the tunnel interface:
•
DOWN (Administratively)—The interface is administratively down.
That is, the interface is shut down with the shutdown command.
•
DOWN—The interface is administratively up but its physical state is
down.
•
UP—Both the administrative and physical states of the interface are
up.
Link layer state of the tunnel interface:
•
DOWN—The protocol state of the interface is down.
•
UP—The protocol state of the interface is up.
Description of the tunnel interface.
Maximum transmit unit allowed on the tunnel interface.
IP address of the tunnel interface.
If no IP address is assigned to the interface, Internet protocol
processing : disabled is displayed, which means that packets cannot
be processed.
Primary indicates the primary IP address of the interface. Sub indicates
a secondary IP address of the interface.
The encapsulation protocol is tunnel.
ID of the service loopback group referenced by the tunnel.
If service loopback group is not specified, service-loopback-group ID
not set is displayed.
Source address of the tunnel.
Destination address of the tunnel.
Bandwidth of the tunnel interface.
156