ProSAFE Single Band 802.11n Wireless Access Point WN203
Router
Internet
LAN segment 1
Figure 18. Repeating the wireless signal in point-to-multipoint bridge mode
To configure the wireless access point to repeat the wireless signal:
1.
Configure the security profiles on the wireless access point (AP2 on LAN Segment 2 in
the previous figure):
a. Select Configuration > Wireless Bridge.
The Bridging screen displays (see the following figure).
b. Select the Enable Wireless Bridging check box.
The Local MAC Address field is a nonconfigurable field that shows the MAC address
of the wireless access point.
c. Select the Wireless Point to Multi-Point Bridge radio button.
The screen adjusts. The profile table shows four security profiles.
AP1
Multipoint
bridge mode
repeating only
Advanced Configuration
86
AP2
Multipoint
bridge mode
repeating only
Multipoint
bridge mode
repeating only
Hub or switch
AP3
LAN segment 2