Factory Default Settings - NETGEAR ProSAFE WN203 Reference Manual

ProSAFE Single Band 802.11n Wireless Access Point WN203
Table 5. Technical specifications (continued)
Feature
Status LEDs
Electrical and physical specifications
Power adapter
Power consumption
Physical specifications
Environmental
specifications
MTBF
Electromagnetic
compliance

Factory Default Settings

You can use the Reset to Factory Defaults button located on the bottom panel of the wireless
access point to reset all settings to their factory default. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset to Factory Defaults
button for approximately 10 seconds. This returns the wireless access point to the factory
configuration settings that are shown in the following table.
Note: Pressing the Reset to Factory Defaults button for a few seconds
simply causes the wireless access point to reboot.
Description
• Power LED
• Test LED
• LAN LED
• WLAN LED
12VDC, 1A; plug is localized to country of sale
4.0W
• Dimensions (h x w x d): 35 x 133 x 173 mm (1.4 x 5.3 x 6.8 in.)
• Weight: 240 g (0.5 lb)
• Operating temperature: 0 to 45°C (32 to 113°F)
Operating humidity: 10–90%, noncondensing
• Storage temperature: –20 to 70°C (–4 to 158°F)
Storage humidity: 5–95%, noncondensing
• At 25°C > 375,000 hours
• At 50°C > 125,000 hours
SRRC
Supplemental Information
108