NETGEAR ProSAFE WN203 Reference Manual page 24

ProSAFE Single Band 802.11n Wireless Access Point WN203
2. Configure the settings as described in the following table:
Setting
Select the Enable radio button to enable the DHCP server. Use the default settings or specify the pool of IP
addresses to be assigned by setting the starting IP address and ending IP address. These addresses
should be part of the same IP address subnet as the wireless access point's LAN IP address.
DHCP Server VLAN ID
Starting IP Address
Stopping IP Address
Subnet Mask
Gateway IP Address
Primary DNS Server
Secondary DNS Server
Primary WINS Server
Description
Enter the VLAN ID for the DHCP server. The VLAN ID range is from 1 to 4094.
The default VLAN is 1.
Enter the first address in the range of IP addresses to be assigned to DHCP
clients. The default address is 192.168.1.02.
Enter the last address in the range of IP addresses to be assigned to DHCP
clients. The default address is 192.168.1.50.
Enter the subnet mask to be used by DHCP clients. The default mask is
255.255.255.0.
Enter the IP address of the default routing gateway to be used by DHCP clients.
The default address is 192.168.0.1.
Enter the IP address of the primary Domain Name System (DNS) server
available to DHCP clients.
Enter the IP address of the secondary DNS server available to DHCP clients.
Enter the IP address of the primary WINS server for the network, if there is any.
Installation and Basic Configuration
24