NETGEAR ProSAFE WN203 Reference Manual page 93

ProSAFE Single Band 802.11n Wireless Access Point WN203
Setting
Country / Region
Firmware Version
Serial Number
Current Time
Current IP Settings
For information about how to change any of these IP settings, see
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings for 802.11b, 802.11g, or 802.11ng
Note: The section heading depends on the configured wireless mode.
Access Point Mode
Channel / Frequency
Rogue AP Detection
Description
The country or region for which the wireless access point is licensed for use. For
information about how to change the country or region, see
System Settings and Time Settings
Note: It might not be legal to operate this wireless access point in a country or region
other than one of those identified in this field.
The version of the firmware that is installed.
The serial number of the wireless access point.
The current time. For information about how to change the time settings, see
Configure Basic General System Settings and Time Settings
The IP address of the wireless access point.
The subnet mask for the address of the wireless access point.
The default IP gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a DHCP server on
your LAN network. Disabled indicates a static IP configuration.
The operating mode of the wireless access point. One of the following modes is
indicated:
• Access Point
• Point-to-Point Bridge
• Point-to-Point Bridge with Access Point
• Multi-Point Bridge with/without client association
For information about how to change the mode, see
page 75.
The channel that the wireless port is using. For information about how to change the
channel and frequency, see
Enabled indicates that rogue AP detection is enabled. Disabled indicates that it is not.
Monitoring
93
on page 20.
Configure the IP Settings
Configure Wireless Bridging
Configure 802.11b/bg/ng Wireless Settings
Configure Basic General
on page 20.
on page 22.
on
on page 25.