ProSAFE Single Band 802.11n Wireless Access Point WN203
Configure Basic General System Settings and Time Settings
After you have successfully logged in to the wireless access point, the basic General system
settings screen displays.
To configure basic system settings:
1.
Select Configuration > System > Basic > General.
The basic General system settings screen displays:
2.
Configure the settings as described in the following table:
Setting
AP Name
Country / Region
3.
Click the Apply button.
Description
This unique name is the wireless access point NetBIOS name. The name is printed
on the label of the wireless access point. The default is netgearxxxxxx, in which
xxxxxx represents the last six digits of the wireless access point MAC address. You
can replace the default name with a unique name up to 15 characters long. The
access point name can be retrieved through SNMP.
From the Country / Region drop-down menu, select the country where the wireless
access point is installed.
Note:
It might not be legal to operate this wireless access point in a region other than
one of the regions that you can select from the drop-down menu.
Installation and Basic Configuration
20