NETGEAR ProSAFE WN203 Reference Manual page 26

ProSAFE Single Band 802.11n Wireless Access Point WN203

To configure the 802.11b/g/n wireless settings:
1. Select Configuration > Wireless > Basic > Wireless Settings.
The basic Wireless Settings screen displays. The following figure shows the 11ng
settings.
Note: The radio wave icon (
mode (b, bg, or ng).
2. Select one of the following 2.4 GHz band radio buttons:
• 11b. Both 802.11n- and 802.11g-compliant devices can connect to the access point
because they are backward compatible.
• bg. 802.11n-compliant devices can connect to the access point because they are
11
backward compatible.
• 11ng. This is the default setting. 802.11b-compliant devices cannot connect to the
access point. If you keep the default setting, go to
When you change the wireless mode, the Turn Radio On check box is automatically
cleared, and all fields, buttons, and drop-down menus onscreen are masked out.
3. Turn on the radio by selecting the Turn Radio On check box.
A pop-up screen displays.
) displays next to the enabled wireless
Installation and Basic Configuration
26
Step 5.