Add/Edit Static Route - ZyXEL Communications NBG6716 User Manual

Figure 87 Network > Static Route
The following table describes the labels in this screen.
Table 55 Network > Static Route
LABEL
Add Static Route
#
Status
Name
Destination
Gateway
Subnet Mask
Modify
Apply
Cancel

16.2.1 Add/Edit Static Route

Click the Add Static Route button or a rule's Edit icon in the Static Route screen. Use this screen
to configure the required information for a static route.
Figure 88 Network > Static Route: Add/Edit
Chapter 16 Static Route
DESCRIPTION
Click this to create a new rule.
This is the number of an individual static route.
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
This field displays a name to identify this rule.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
This parameter specifies the IP network subnet mask of the final destination.
Click the Edit icon to open a screen where you can modify an existing rule.
Click the Delete icon to remove a rule from the NBG6716.
Click Apply to save your changes back to the NBG6716.
Click Cancel to begin configuring this screen afresh.
NBG6716 User's Guide
126