Add/Edit Static Route - ZyXEL Communications LTE3301 Series User Manual

Network > Routing > Static Route
Fig ure 64
The following table describes the labels in this screen.
Table 42 Network > Routing > Static Route
L ABEL
Add Static Route
#
Status
Destination
Subnet Mask
Gateway
Modify
12.2.1 Add/ Edit Sta tic Ro ute
Click the
Add Sta tic Ro ute
configure the required information for a static route.
Network > Routing > Static Route: Add/Edit
Fig ure 65
The following table describes the labels in this screen.
Table 43 Network > Routing > Static Route: Add/Edit
L ABEL
Static Route
Destination IP
Address
Chapter 12 Routing
DESC RIPT IO N
Click this to create a new rule.
This is the number of an individual static route.
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
This parameter specifies the IP network subnet mask of the final destination.
This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
Click the icon to open a screen where you can modify an existing rule.
Edit
Click the icon to remove a rule from the LTE3301.
De le te
button or a rule's
DESC RIPT IO N
Select to enable or disable this rule.
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet mask
of 255.255.255.255 in the subnet mask field to force the network number to be identical to the
host ID.
LTE3301 Series User's Guide
icon in the
Edit Sta tic Ro ute
99
screen. Use this screen to