Using The Sat Command Line Prompt - Avaya S8700 Series Installing And Configuring

6. Open the MS Internet Explorer Web browser to access the Maintenance Web Interface.
If you are connected directly, in the Address field, type 192.11.13.6.
●
If you are connected remotely through a modem, in the Address field, type in the IP
●
address or the DNS host name of the media server.
Note:
The first time that you log in, you see a message that asks you to install a security
Note:
certificate. Follow the instructions for your particular browser to accept the
certificate. You can also install the certificate on your computer with the
instructions in the online Help for your browser.
7. When prompted, log in.
8. When you see a message that asks Do you want to suppress alarms?, select Yes.
9. Click Launch Maintenance Web Interface.

Using the SAT command line prompt

Use a remote Secure Shell (SSH) or terminal emulation session to access the Communication
Manager SAT command line prompt.
Type of connection
Using SAT with SSH:
Using SAT with Terminal
Emulation
Installing and Configuring the Avaya S8700-Series Media Server
See Accessing the command line interface of the server with
SSH on page 77.
To use a command line interface in a terminal emulation window,
open your terminal emulation application. Configure the terminal
emulation program port settings as follows:
Speed: 115200 baud or 9600 baud if you use a serial
●
modem connection
No parity
●
8 data bits
●
1 stop bit
●
No flow control
●
NOTE: Avaya Native Configuration Manager, Avaya Terminal
Emulation, and HyperTerminal are the only terminal emulation
programs that Avaya supports.
Use either the IP address or the DNS host name to establish a
network connection to the active media server. Use port 5023 for
this connection. Use SAT commands on the active media server
only. When prompted, log in to the media server as craft.
Using the SAT command line prompt
Procedure
February 2007
83