Configure The Server_1 Network - ZyXEL Communications NWA-3160 User Manual

Each SSID profile already uses a different pre-shared key.
In this example, you will configure access limitations for each SSID profile. To do
this, you will take the following steps.
Configure the SERVER_1 network's SSID profile to use specific MAC filter and
1
layer-2 isolation profiles.
Configure the SERVER_1 network's MAC filter profile.
2
Configure the SERVER_1 network's layer-2 isolation profile.
3
Repeat steps 1 ~ 3 for the SERVER_2 network.
4
Check your settings and test the configuration.
5
To configure layer-2 isolation, you need to know the MAC addresses of the devices
on your network, which are as follows.
Table 5 Tutorial: Example Network MAC Addresses
DEVICE
NWA
Secure Server 1
Secure Server 2
Workstation
Switch
Security gateway E
To configure MAC filtering, you need to know the MAC addresses of the devices
Alice and Bob use to connect to the network, which are as follows.
Table 6 Tutorial: Example User MAC Addresses
USER
Alice
Bob

3.5.4 Configure the SERVER_1 Network

First, you will set up the SERVER_1 network which allows Alice to access secure
server 1 via the network switch.
You will configure the MAC filter to restrict access to Alice alone, and then
configure layer-2 isolation to allow her to access only the network router, the file
server and the Internet security gateway.
NWA-3160 Series User's Guide
LABEL MAC ADDRESS
Z BB:AA:99:88:77:66
1 AA:99:88:77:66:55
2 99:88:77:66:55:44
C 88:77:66:55:44:33
D 77:66:55:44:33:22
66:55:44:33:22:11
MAC ADDRESS
11:22:33:44:55:66
22:33:44:55:66:77
Chapter 3 Tutorials
59