Assigning An Acl To A Port Group; Assigning An Acl To A Port - 3Com 4200G 12-Port Configuration Manual

Configuration example
# Apply ACL 2000 to VLAN 10 to filter the inbound packets of VLAN 10 on all the ports.
<Sysname> system-view
[Sysname] packet-filter vlan 10 inbound ip-group 2000

Assigning an ACL to a Port Group

Configuration prerequisites
Before applying ACL rules to a VLAN, you need to define the related ACLs. For information about
defining an ACL, refer to section
Configuring Layer 2
Configuration procedure
Table 1-7 Assign an ACL to a port group
Operation
Enter system view
Enter port group view
Apply an ACL to the port
group
After an ACL is assigned to a port group, it will be automatically assigned to the ports that are
subsequently added to the port group.
Configuration example
# Apply ACL 2000 to port group 1 to filter the inbound packets on all the ports in the port group.
<Sysname> system-view
[Sysname] port-group 1
[Sysname-port-group-1] packet-filter inbound ip-group 2000

Assigning an ACL to a Port

Configuration prerequisites
Before applying ACL rules to a VLAN, you need to define the related ACLs. For information about
defining an ACL, refer to section
Configuring Layer 2
Configuring Basic
ACL.
Command
system-view
port-group group-id
packet-filter inbound acl-rule
Configuring Basic
ACL.
ACL, section Configuring Advanced
—
—
Required
For description on the acl-rule
argument, refer to ACL Command.
ACL, section Configuring Advanced
1-10
ACL, section
Description
ACL, section