Soft Switch: #10 - Konica Minolta bizhub 160 Service Manual

Field Service Ver. 1.0 Apr. 2005
16.8.10

SOFT SWITCH: #10

Bit Designation
No.
8 Print out RTN page
report
7 Confirmation report
result field
6 Get gap time
between digit for
5
pulse dial
4 RX PIP T.30 com-
mand after send out
MPS command
3 Received DIS signal
within reception
2 Transmission time
limitation
1 Audio alarm after
communication fail
• Bit 8: If this bit set to 1, machine will print out confirmation report after each transaction
for TX/RX RTN signal.
• Bit 7: If this bit is set to1, the result field will show "NG" instead of "OK" in the confirmation
report and activity report or checking the result on the LCD.
• Bit 2: For Manual Tx only.
16. Soft Switch Set (bizhub 160f/bizhub 161f only)
Function
0: Not to Print
1: Print Out RTN page report after transaction for TX/
RX RTN signal
0: Print "OK"
1: Print "NG" in case of sending or receiving RTN signal
Value (ms) 550
Bit 6 0
Bit 5 0
0: Send DCS at current speed
1: Return to Tx phase B waiting for DIS signal
0: Repeat sending DIS/DTC again until time out
1: Disconnected after sending DCN signal
0: No any limitation until document jam
1: Limit to 8 minutes from data phase
0: Not to alarm after transaction fail
1: Alarm 3 seconds after disconnected
650 750 850
0 1 1
1 0 1
Initial
Setting
Bit HEX
1 A
0
1
0
0 1
0
0
1
191