Firmware Upgrade; Preparations For Firmware Rewriting; Firmware Rewriting; Installing The Printer Driver/ Twain Driver Using Plug And Play - Konica Minolta bizhub 160 Service Manual

5. Firmware upgrade

5. Firmware upgrade
5.1

Preparations for Firmware rewriting

NOTE
• The TWAIN driver must already be installed on the host computer to be used for
updating the firmware.
• If the printer driver or TWAIN driver is not installed, follow the procedure described
below to install the driver.
• If the driver is already installed, skip to "Procedure for Updating the Firmware"
and update the firmware.
5.2

Firmware rewriting

5.2.1

Installing the Printer Driver/ TWAIN Driver Using Plug and Play

<For Windows XP>
1. Start up the host computer, and then insert the CD-ROM into the CD-ROM drive.
2. Turn on the printer.
3. Use a USB cable to connect the printer to the host computer.
4. In the "Found New Hardware Wizard" dialog box, select "Install from a list or specific
location [Advanced]", and then click the [Next] button.
5. Below "Search for the best driver in these locations.", select "Include this location in the
search", and then click the [Browse] button.
6. Specify "\Corresponding_language\2K_XP" on the CD-ROM, and then click the [OK]
button.
7. Click the [Next] button, and then click the [Finish] button.
8. When the "Found New Hardware Wizard" dialog box appears again, repeat steps 4
through 7 to install all drivers.
<For Windows 2000>
1. Start up the host computer, and then insert the CD-ROM into the CD-ROM drive.
2. Turn on the printer.
3. Use a USB cable to connect the printer to the host computer.
4. In the "Install Hardware Device Drivers" dialog box, select "Search for a suitable driver
for my device (recommended)", and then click the [Next] button.
5. In the "Locate Driver Files" dialog box, select "Specify a location", and then click the
[Next] button.
6. Click the [Browse...] button, specify "\Corresponding_language\2K_XP" on the CD-
ROM, and then click the [OK] button.
7. Click the [OK] button, and then continue following the instructions in the dialog boxes
that appear until the "Completing the Found New Hardware Wizard" dialog box
appears.
8. Click the [Finish] button.
9. When the "Found New Hardware Wizard" dialog box appears again, repeat steps 4
through 8 to install all drivers.
<For Windows Me/98>
1. Start up the host computer, and then insert the CD-ROM into the CD-ROM drive.
2. Turn on the printer.
3. Use a USB cable to connect the printer to the host computer.
4. In the "Install Hardware Device Drivers" dialog box, click the [Next] button, select
"Search for a suitable driver for my device (recommended)", and then click the [Next]
button again.
22

Field Service Ver. 1.0 Apr. 2005