Konica Minolta bizhub 160 Service Manual page 162

Field Service Ver. 1.0 Apr. 2005
E. VERTICAL EDGE ERASE
Functions • To change the laser emission timing to adjust the width of the image area that is
Use • When the PH unit has been replaced
• When the user requests a smaller margin
Adjustment Speci-
fication
Adjustment To reduce the margin........ Decrease the setting.
Instruction To increase the margin..... Increase the setting.
Adjustment 1. Enter Service's Choice in the Service mode.
Procedure 2. Select "VERTICAL EDGE ERASE."
3. Specify the setting.
4. Specify settings for the "LEADING EDGE ERASE" and the "TRAILING EDGE
F. FLS PAPER SIZE
Functions • To specify the paper size for foolscap.
Use • When the FLS paper size has been changed
• Upon setup
Setting/Procedure • The default setting is "330∗210" mm.
G. TX SPEED
Functions/Use • Transmit start speed setting. Choose the mode from among the following.
Setting/Procedure • The default setting is "V.34."
H. RX SPEED
Functions/Use • Reception start speed setting. Choose the mode from among the following.
Setting/Procedure • The default setting is "V.34."
erased on both sides (main scan direction).
4022D503AA
ERASE" functions in the same way.
330∗203 "330∗210"
"V.34" : 33600, 31200, 28800, 26400, 24000, 21600, 19200, 16800
V.17 : 14400, 12000, 9600, 7200
V.29 : 9600, 7200
V.27 : 4800, 2400
"V.34" : 33600, 31200, 28800, 26400, 24000, 21600, 19200, 16800
V.17 : 14400, 12000, 9600, 7200
V.29 : 9600, 7200
V.27 : 4800, 2400
13. Service Mode (bizhub 160f/bizhub 161f)
•Specify the amount erased at the both
sides (width of C) of the paper.
C
Specifications
0 ± 2.0 mm
Setting Range
C
0 to 5 (1 increment = 1 mm)
The default setting is "4" mm
330∗216 337∗206 (mm)
129