Soft Switch List - Konica Minolta bizhub 160 Service Manual

Field Service Ver. 1.0 Apr. 2005

16.7 Soft switch list

Switch Bit No.
No.
# 01 8 Detect CED or not after Dial
2/1 V.34 CI signal byte number reserved
# 02 8/7 Time between phase C to phase D signal in V.17
6 Header TX selection open to user
3/2 Transmit RTN signal level criteria
1 Sent N.G page
# 03 8 Send out NSF frame with station ID
7 Number of pause within phone number
6 Re-dial prohibit for NO ANSWER
4/3/2/1 RX level setting
# 04 4 Visible alarm for RTN signal
3 Audible alarm or RTN signal
1 Polarity change detection
# 05 8/7 Push Button on/off Timing (PB)
6/5 Relation between dialed No. and No. of dial pulse
4/3/2/1 Dial pulse make ratio select (MR)
# 06 8/7 Ring on time to ignore ring off time at 1st cycle
4/3 Ring off time at 1 st. cycle to approve incoming ring
# 07 8 Dial tone or busy tone detection
7 PSTN/ PBX setting
6 PBX dial tone detect
5 Dial mode select
4/3/2/1 Tx level select for PSK/ FSK
# 08 8 Sending RTN signal level
7 Detect busy tone after dialing
6 Sending CED signal after connection
4/3/2/1 Redial interval
# 09 8/7 Ringer frequency detection
5 TSI/ CSI Append "+"
2/1 Time from RX DIS signal to send DCS signal
# 10 8 Print out RTN page report
7 Confirmation report result field
6/5 Get gap time between digit for pulse dial
4 RX PIP T.30 command after send out MPS command
3 Received DIS signal within reception
2 Transmission time limitation
1 Audio alarm after communication fail
# 11 7 Detect dial tone after pre-fix number
6 Pulse dial allowed to select
1 DTMF high frequency dB value
16. Soft Switch Set (bizhub 160f/bizhub 161f only)
Designation Page No.
☞
183
☞
184
☞
185
☞
186
☞
187
☞
188
☞
188
☞
189
☞
190
☞
191
☞
192
179