Konica Minolta bizhub 160 Service Manual page 307

23. FAX error (bizhub 160f/bizhub 161f only)
Code
00B1 Did not finish V.8 procedure or detect V.21 signal after ANSam signal within 35 seconds.
00B2 Did not detect phase B signal after our side sending CJ signal within 30 seconds.
00B3 Did not detect correct V.21 or JM signal after sending CM signal.
00B4 Did not detect correct phase B signal within 25 second after CM/JM signal exchange.
00B5 Did not detect phase C signal after phase B within 25 seconds.
00B6 Did not detect phase D signal within 25 seconds after CM/JM exchange.
00B7 Did not detect phase E signal after phase D within 30 seconds.
00B8 Remote side disconnect after our side sent DCS signal in V.34.
00B9 Receive T.30 signal other than DIS,DCS,CFR after sending DCS signal in V.34.
00BA Did not receive correct signal after our side sent DTC signal in V.34.
00BB Every time our side received DIS signal after sending DTC in V.34.
00BC Modem not ready within 10 second after entering primary channel in V.34.
00BD Can not detect correct V.21 or JM signal after detected FSK frequency.
00BE Remote side no document to be polled after V8 handshaking.
00BF Capability not match after V8 handshaking.
00C0 Remote side disconnect before entering primary channel in V.34.
00C1 At phase-D, transmitting unit sends out EOP 3 times consecutively, but receives no answer
from receiving unit.
00C2 Remote side disconnect after sending out V.8 CM signal.
00C4 After sending MPS signal, the received signal is not one of MCF, RTN, PIP, PIN, RTP, DCN.
00C5 Received DCN signal after sending MPS signal.
00C9 At phase-D, sending MPS 3 times consecutively, but no answer from receiving unit.
00CA After sending EOP signal, the received signal is not one of MCF, RTN, PIP, PIN, PRI-EOP,
DCN.
00CB After sending EOP signal, the received signal is DCN signal.
00CC After sending EOM signal, the received signal is not one of MCF, RTN, PIP, PIN, RTP, DCN.
00CD At phase-D, transmitting unit sends out EOM 3 times consecutively, but receives no answer.
00CE At phase-D, transmitting unit sends out EOM, but receives DCN.
00CF Received incorrect signal after sending DTC signal for V.34 polling.
00D0 Received ERR signal after sending EOR_NULL.
00D1 ECM TX received wrong command in phase D after PPS-EOP. (not PPR, MCF, PIP,
PIN,.....).
00D2 Receive DCN after send command PPS-EOP signal.
00D3 Received DCN after sending PPS_NULL signal.
00D4 Received DCN after sending PPS_EOM signal.
00D8 Did not detect correct phase C signal for polling within 25 seconds.
00D9 Did not detect correct phase C signal after detecting silence after phase B.
00DA Did not detect phase D signal within 30 seconds or remote side hang up over 6 seconds.
00DB Did not receive any T.30 signal within 15 seconds in phase D.
00DC Received T.30 signal in phase D other than DCS,DIS or DTC.
00DD Remote side not the same model or no mailbox ID defined for mailbox TX.
00DE Remote side no SUB capability in V.34.
274
Field Service Ver. 1.0 Apr. 2005
Possible Causes of Error.