Pcl Board (Bizhub 161/161F Only); Controller/Mechanical Control Board - Konica Minolta bizhub 160 Service Manual

Field Service Ver. 1.0 Apr. 2005
6.3.5

PCL Board (bizhub 161/161f only)

1. Remove the Rear Cover.
6.3.6

Controller/Mechanical Control Board

1. Remove the Rear Cover.
☞ 32
2. Remove the NIC Board. (only when the option NC-501 is mounted)
☞ 34
3. Remove the NCU Board. (bizhub 160f/161f only)
☞ 34
4. Remove the PCL Board. (bizhub 161/161f only)
☞ 35
*
4980S536AA
4980S537AA
*
4980D003AC
4980D004AB
2. Disconnect all connectors from the
PCL Board.
3. Remove four screws.
4. Remove the PCL Board.
5. Disconnect all connectors and flat
cables from the Controller/Mechani-
cal Control Board.
NOTE
• The two connectors marked with
"*" in the illustration are provided
for bizhub 160f/161f only.
• Use utmost care not to snap off the
flat cable.
6. Remove six screws.
7. Remove the Controller/Mechanical
Control Board.
6. Other
35