Firmware Upgrade - Konica Minolta bizhub 160 Service Manual

3. Firmware upgrade

3. Firmware upgrade
1. Connect the Network Interface Card and PC with the network by using the RJ45 net-
work cables.
2. Start up the [MS-DOS prompt] or [Command prompt] of PC.
3. Input "ftp", and then input the [IP address].
C:\>ftp XXX.XXX.XXX.XXX
NOTE
Confirm with the user's system administrator or network administrator on the IP
address.
4. Press the "Enter" key.
5. Check that the following message is displayed, and that the PC has been connected
with the NIC (Network Interface Card Board).
Connected_to_XXX.XXX.XXX.XXX
220_NET+ARM_FTP_SERVER_1.0_ready
USER(XXX.XXX.XXX.XXX:(none)):
6. Press the "Enter" key.
NOTE
In case of using the Windows XP or Windows 2003 Server, type "(none)" and press
the Enter key.
USER(XXX.XXX.XXX.XXX:(none)): (none)
7. Check that the following message is displayed, and that you could log on to the NIC
through the PC.
230_User_none_logged_in.
8. Input "bin". (Data transfer is switched to the binary mode.)
9. Press the "Enter" key.
ftp>bin
10. The following messages is displayed.
200_Type_set_to_I.
11. Type "put" and then the location and name of the update file.
ftp>put X:\XXX.bin
12. Press the "Enter" key. (Wait to a while until data transfer is completed.)
13. Check that the following message is displayed, and data has been properly transferred
to the NIC from the PC.
200_PORT_command_OK
150_About_to_open_data_connection.
226_Transfer_complete.
ftp: xxxbytes_sent_in_xxxSeconds_xxKbytes/sec.
14. Type "get flash" and press the Enter key. (Wait to a while until data transfer is com-
pleted.)
ftp>get flash
15. The following messages will appear.
200_PORT_command_OK
150_About_to_open_data_connection.
226_Transfer_complete
ftp: xxxbytes_received_in_xxxSeconds_xxKbytes/sec.
16. Input "quit", and then press the "Enter" key.
ftp>quit
221 Goodbye.
6
Field Service Ver. 1.0 Apr. 2005