Konica Minolta bizhub 160 Service Manual page 138

Field Service Ver. 1.0 Apr. 2005
C. TRAILING EDGE ERASE
Functions • To change the laser emission timing to adjust the width of the image area that is
Use • When the PH unit has been replaced
• When the user requests a smaller margin
Adjustment Speci-
fication
Adjustment To reduce the margin........ Decrease the setting.
Instruction To increase the margin..... Increase the setting.
Adjustment 1. Enter Service's Choice in the Service mode.
Procedure 2. Select "TRAILING EDGE ERASE".
3. Specify the setting.
4. Specify settings for the "LEADING EDGE ERASE" and the "VERTICAL EDGE
D. VERTICAL EDGE ERASE
Functions • To change the laser emission timing to adjust the width of the image area that is
Use • When the PH unit has been replaced
• When the user requests a smaller margin
Adjustment Speci-
fication
Adjustment To reduce the margin........ Decrease the setting.
Instruction To increase the margin..... Increase the setting.
Adjustment 1. Enter Service's Choice in the Service mode.
Procedure 2. Select "VERTICAL EDGE ERASE".
3. Specify the setting.
4. Specify settings for the "LEADING EDGE ERASE" and the "TRAILING EDGE
erased at the trailing edge.
4022D503AA
ERASE" functions in the same way.
erased on both sides (main scan direction).
4022D503AA
ERASE" functions in the same way.
12. Service Mode (bizhub 160/bizhub 161)
•Specify the amount erased at the trailing
B
edge (width of B) of the paper.
Specifications
0 ± 2.0 mm
Setting Range
0 to 5 (1 increment = 1 mm)
The default setting is "4" mm
•Specify the amount erased at the both
sides (width of C) of the paper.
C
Specifications
0 ± 2.0 mm
Setting Range
C
0 to 5 (1 increment = 1 mm)
The default setting is "4" mm
105