Konica Minolta bizhub 160 Service Manual page 305

23. FAX error (bizhub 160f/bizhub 161f only)
Code
0031 Received incorrect signal at phase D (not EOP, MPS, EOM, DCS PPS_Q, PPS_Q, etc.).
0032 Did not receive carrier signal within 6 sec.after sending MCF. or RTP, RTN signal.
0033 Received DCN signal at phase D within pages (not last page).
0039 In non-ECM mode, when machine already received the data but next line data doesn't
receive within 13.1 seconds.
003F Remote side TSI not programmed in machine one touch or speed dial directory.
0040 Did not receive carrier signal within 6 sec. after sending CTR.
0041 Did not receive carrier signal within 6 sec. after sending PPR.
0042 Did not receive correct signal after sending RNR signal.
0043 Received incorrect signal at phase D in ECM mode.
0044 Did not receive carrier signal /FSK signal within 6 sec. after sending MCF in ECM mode.
0045 Did not receive any correct signal after sending RNR response with ERR signal.
0046 Receive incorrect signal when sending RNR response with ERR signal.
0047 Did not receive correct signal after sending ERR signal.
0048 Did not receive correct signal after receiving PPS_PRI_Q or PRI_Q, EOR_PRI_Q.
0049 Did not receive correct signal after sending PIP/PIN signal within 13 sec.
004A Line energy over threshold lasts for 60 seconds after MCF and can not detect FSK or carrier
signal in ECM mode.
004B Can not detect correct FSK signal even though detected FSK tone within 6 sec.
004C Command hand shake fail when V.34 RX.
004E Receive DCN signal after sending DIS in V.34.
004F Remote side disconnected after sending ANSam in V.8 phase.
0050 Did not receive any correct signal after sending CJ signal in V.8 phase.
0051 Did not receive phase C signal after phase B within 20 seconds in V.34.
0052 Did not receive phase D signal after phase C within 20 seconds in V.34.
0053 Modem disconnect after phase D in V.34.
0054 Remote side disconnected after phase D in V.8.
0055 Receive incorrect signal after sending DIS signal in V.34.
0056 Modem disconnect after sending CFR in V.34.
0057 Did not detect image signal within 6 seconds after sending CFR.
0058 Did not detect image signal within 6 seconds after modem enter to phase A in V.34.
0059 Relay box is not registered even when Relay job has been received.
005A Modem can not detect any correct ECM frame within 3 minutes in phase C.
005B Did not detect phase E signal after primary channel within 6 seconds.
005C Detect busy tone within control channel after phase C.
005D Remote-side disconnect at phase C (V.34).
005E Did not detect control channel signal after received RCP frame within 6 seconds.
005F Did not detect silence after sending JM signal for polling TX function.
0060 There are no bulletin files to be polled in V.34.
0061 Machine can not detect V.21 or V.8 signal within 35 seconds.
0062 Modem disconnect in phase D after our side sending out flag sequence in control channel.
0063 Did not receive any flag sequence in control channel within 6 seconds in phase D.
272
Field Service Ver. 1.0 Apr. 2005
Possible Causes of Error.