Setting The Paper Size Using The Control Panel - Ricoh SP 5200S Operating Instructions Manual

2. Paper Guides
3. Set the paper size using the printer driver or the control panel.
• If the display indicates that there is no paper on the bypass tray even though there is paper on it,
remove the paper and then place it on the bypass tray again.
• Load only as much paper as can be held between the guides on the bypass tray. Overloading the
bypass tray can result in misfeeds and skewed images.
1
• To support A4 , 8 /
• To prevent multiple sheets from being fed at once, fan paper before placing it on the tray.
• When loading thick paper, thin paper or OHP transparencies, set paper thickness and paper type.
• The number of sheets that can be loaded in the bypass tray depends on the paper type.
• When loading letterhead paper, see "Printing on Orientation-Fixed or Two-Sided Paper".
• Depending on the environment where the machine is being used, you might at times hear a rustling
noise from paper moving through the machine. This noise does not indicate a malfunction.
• When [Panel Key Sound] is turned off, it will not sound if you insert paper into the bypass tray. For
details about [Panel Key Sound], see "System Settings", Network and System Settings Reference.
• For details about setting printer drivers, see the printer driver Help.
• p.68 "Printing on Orientation-Fixed or Two-Sided Paper"

Setting the Paper Size Using the Control Panel

Follow the procedure below to set the machine using the control panel when loading standard size
paper onto the bypass tray.
1. Press the [User Tools/Counter] key on the control panel.
11 or larger paper sizes, pull out the extender.
2
CCS003
Setting Paper on the Bypass Tray
2
59