Setting The Paper Size Using The Control Panel - Ricoh Aficio MP C2050 Operating Instructions Manual

2. Gently insert paper face down into the bypass tray until the beeper sounds, and then adjust
the paper guides to the paper size.
If the paper size of the paper guide and the paper do not match, skewing and misfeeds might occur.
Do not stack paper over the limit mark, otherwise a skewed image or misfeeds might occur.
Open out the extender to support paper sizes larger than A4 , 8
Fan the paper to get air between the sheets to avoid a multi-sheet feed.
1. Extender
2. Paper Guide
3. Set the paper size using the printer driver or the control panel.
• When loading thick paper, thin paper, or OHP transparencies, set paper size and paper type.
• The number of sheets that can be loaded in the bypass tray depends on the paper type.
• When loading letterhead paper, see "Loading Paper", About This Machine.
• Depending on the environment where the machine is being used, you might at times hear a rustling
noise from paper moving through the machine. This noise does not indicate a malfunction.
• When the Panel Key Sound is turned off, it will not sound if you insert paper into the bypass tray. For
details about Panel Key Sound, see "System Settings", Network and System Settings Guide.
• For details about setting printer drivers, see the printer driver Help.

Setting the Paper Size Using the Control Panel

Follow the procedure below to set the machine using the control panel when loading standard size paper
onto the bypass tray.
• The following procedures are not required if you select [Driver/Command] from [Bypass Tray Setting
Priority] in [System] of [Printer Features] (see "System"). In that case, set the paper size using the printer
driver.
20
2
1
BMG012S
1
/ " 11 " .
2