Ricoh SP 5200S Operating Instructions Manual page 38

1. Preparing the Machine
7. Click [Next >].
8. Select the machine model you want to use.
The machine name can be changed in the [Change settings for 'Printer Name'] box.
1
9. Double-click the machine name to display the printer settings.
The details shown in [Comment], [Driver], and [Port] vary depending on the operating system,
machine model, and port.
10. Click [Port], and then click [Add].
11. Click [SmartDeviceMonitor for Client 2], and then click [OK].
12. Click [IPP].
13. In the [Printer URL] box, enter "http://(machine's IP address or host name)/printer" as
the machine's address.
If the server authentication is issued, to enable SSL (a protocol for encrypted communication), enter
"https://(machine's IP address or host name)/printer" (Internet Explorer 5.01, or a higher version
must be installed).
(example IP address: 192.168.15.16)
http://192.168.15.16/printer
https://192.168.15.16/printer
You can enter "http://(machine's IP address or host name)/ipp" as the machine's address.
If the address is "192.168.001.010", you must enter it as "192.168.1.10" to connect to the
machine.
14. Enter a name for identifying the printer in [IPP Port Name]. Use a name different from the
one of any existing ports.
If a name is not specified here, the address entered in the [Printer URL] box becomes the IPP port
name.
15. Click [Detailed Settings] to make necessary settings, and then click [OK].
For details about the settings, see SmartDeviceMonitor for Client Help.
16. Click [OK].
17. Check that the port of the selected printer is displayed in [Port].
18. Set a user code, if necessary.
Up to 8 numeric characters can be entered. No alphabetic characters or symbols can be entered.
19. Select the [Default Printer] check box to configure the printer as default.
20. Click [Continue].
Installation starts.
21. Click [Finish].
36