Table of Contents
Advertisement
5.
Enable the following features in the management module:
External Ports (I/O Module Tasks > Admin/Power/Restart > Advance Setup)
External management over all ports (Configuration > Advanced Configuration)
This setting is required if you want to access the management network through the exter-
nal ports on the GbE Switch Module.
The default value is Disabled for both features. If these features are not already enabled,
change the value to Enabled, then Save.
N
– In Advanced Configuration > Advanced Setup, enable "Preserve new IP configura-
OTE
tion on all switch resets," to retain the switch's IP interface when you restore factory defaults.
This setting preserves the management port's IP address in the management module's memory,
so you maintain connectivity to the management module after a reset.
You can now start a Telnet session, Browser-Based Interface (Web) session, a Secure Shell ses-
sion, or a secure HTTPS session to the GbE Switch Module.
Connecting to the Switch via Telnet
Use the management module to access the GbE Switch Module through Telnet. Choose
I/O Module Tasks > Configuration from the navigation pane on the left. Select a bay number
and click Advanced Configuration > Start Telnet/Web Session > Start Telnet Session. A
Telnet window opens a connection to the Switch Module (requires Java 1.4 Plug-in).
Once that you have configured the GbE Switch Module with an IP address and gateway, you
can access the switch from any workstation connected to the management network. Telnet
access provides the same options for user and administrator access as those available through
the management module, minus certain Telnet and management commands.
To establish a Telnet connection with the switch, run the Telnet program on your workstation
and issue the Telnet command, followed by the switch IP address:
telnet <switch IP address>
Running Telnet
Once the IP parameters on the
a Telnet connection. From the management module, you can establish a Telnet connection with
the switch.
You will then be prompted to enter a password as explained on
40M2420, April 2007
are configured, you can access the CLI using
GbE Switch Module
Chapter 1: The Command Line Interface
Alteon OS Command Reference
page
27.
23
Advertisement
Table of Contents
