Routing Information Protocol Interface Configuration - Nortel Alteon OS 40M2420 Command Reference Manual

/cfg/l3/rip/if <interface number>

Routing Information Protocol Interface Configuration

[RIP Interface 1 Menu]
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is
turned off by default.
N – Do not configure RIP1 parameters if your routing equipment uses RIP version 2.
OTE
Table 6-71 RIP Interface Menu Options (/cfg/l3/rip/if)
Command Syntax and Usage
version 1|2|both
Configures the RIP version used by this interface. The default value is version 2.
supply disable|enable
When enabled, the switch supplies routes to other routers. The default setting is enabled.
listen disable|enable
When enabled, the switch learns routes from other routers. The default setting is enabled.
poison disable|enable
When enabled, the switch uses split horizon with poisoned reverse. When disabled, the switch uses
only split horizon. The default setting is disabled.
split disable|enable
Enables or disables split horizon. The default setting is enabled.
40M2420, April 2007
version - Set RIP version
supply - Enable/disable supplying route updates
listen - Enable/disable listening to route updates
poison - Enable/disable poisoned reverse
split - Enable/disable split horizon
trigg - Enable/disable triggered updates
mcast - Enable/disable multicast updates
default - Set default route action
metric - Set metric
auth - Set authentication type
key - Set authentication key
enable - Enable interface
disable - Disable interface
current - Display current RIP interface configuration
Alteon OS Command Reference
Chapter 6: The Configuration Menu 267