Table of Contents
Advertisement
Setup Part 4: IP Configuration
The system prompts for IP parameters.
IP Interfaces
IP interfaces are used for defining subnets to which the switch belongs.
Up to 128 IP interfaces can be configured on the
each IP interface provide the switch with an IP presence on your network. No two IP interfaces
can be on the same IP subnet. The interfaces can be used for connecting to the switch for
remote configuration, and for routing between subnets and VLANs (if used).
1.
Select the IP interface to configure, or skip interface configuration at the prompt:
IP Config:
IP interfaces:
Enter interface number: (1-128)
If you wish to configure individual IP interfaces, enter the number of the IP interface you with
to configure. To skip IP interface configuration, press <Enter> without typing an interface
number and go to
N
– Interface 128 is reserved for switch management. If you change the IP address of
OTE
IF 128, you can lose the connection to the management module. Use the management module
to change the IP address of the GbE Switch Module.
2.
For the specified IP interface, enter the IP address in dotted decimal notation:
Current IP address:
Enter new IP address:
To keep the current setting, press <Enter>.
3.
At the prompt, enter the IP subnet mask in dotted decimal notation:
Current subnet mask:
Enter new subnet mask:
To keep the current setting, press <Enter>.
40M2420, April 2007
"Default Gateways" on page
0.0.0.0
Alteon OS Command Reference
. The IP address assigned to
GbE Switch Module
40.
0.0.0.0
Chapter 2: First-Time Configuration
39
Advertisement
Table of Contents
