Table of Contents
Advertisement
Alteon OS Command Reference
4.
At the prompt, decide whether to make the changes permanent:
Save changes to flash? [y/n]
Enter
y
are normally saved at this point.
5.
If you do not apply or save the changes, the system prompts whether to abort them:
Abort all changes? [y/n]
Enter
y
N
– After initial configuration is complete, it is recommended that you change the default
OTE
passwords as shown in
Optional Setup for Telnet Support
N
– This step is optional. Perform this procedure only if you are planning on connecting to
OTE
the GbE Switch Module through a remote Telnet connection.
1.
Telnet is enabled by default. To change the setting, use the following command:
>> # /cfg/sys/access/tnet
2.
Apply and save SNMP and /or telnet configuration(s).
>> System# apply
>> System# save
42
Chapter 2: First-Time Configuration
to save the changes to flash. Enter
to discard the changes. Enter
"Setting Passwords" on page
to continue without saving the changes. Changes
n
to return to the "Apply the changes?" prompt.
n
43.
40M2420, April 2007
Advertisement
Table of Contents
