Siemens TC12 Installation, Commissioning And Maintenance Handbook page 47

TC12 Installation, Commissioning & Maintenance Handbook
Switch S1 PCB Address
Set the switch on the card closest to the PSU PCB to 0, the next card to 1 and so
on up to F if 16 boards are fitted.
Connectors PL1 and PL2
These connectors are used to take the digital outputs out of the cabinet. Either a
ribbon cable kit (667/1/22742/000) or a discrete wire cable kit (667/1/22742/001)
are used to make up the cables on installation. The pin outs are as follows:
666/HE/43100/000 Page 37 Issue 10