Siemens TC12 Installation, Commissioning And Maintenance Handbook page 27

Set the I/O Port addresses of the boards using DIP switch 1 (DS1) positions 9 to
11, as shown below:
Board SW9
1 ON
2 ON
3 OFF
4 ON
Set the interrupts using DIP switch 2 (DS2), positions 1 to 8, as shown below:
Board SW1
1 OFF
2 OFF
3 OFF
4 OFF
2.2.2.8.2 DIGI AccelePort 16e
The DIGI PC/16i comprises a full length ISA card (DIGI part number 60000200)
and an IMD Distribution Unit (labelled Digi AccelePort 16e ISA DB25M RS232).
The PC board has a single jumper (J1) and 2 DIP switches (DS1 and DS2).
The jumper is used to set the local program memory size, which should be 64K.
The jumper has 3 pins which are numbered from left to right. The jumper should
be set so that pins 2 and 3 are bridged.
The setting of the2 DIP switches, DS1 and DS2, is the same as for the DIGI
PC/16i board (See 2.2.2.8.1).
2.2.2.8.3 DIGI AccelePort Xem
The DIGI AccelePort Xem comprises a three quarter length Xem ISA Host Adapter
(419/4/95931/000 - DIGI part number 77000211), a 16em DB25 Module
(653/4/05229/000 - DIGI part number 76000073) and a Xem 5ft Cable
(707/4/08514/000 - DIGI part number 62080060). Each 16em DB25 Module is
supplied with a short cable which enables a maximum of 4 16em DB25 Modules to
be daisy chained together. Two 16em DB25 Modules may be powered from the
ISA Host Adapter. Additional Modules require auxiliary power supplies
(605/4/08678/000 - DIGI part number 76000321).
The PC must be powered off before the Xem host adapter card is installed. The
PC should remain off until the 16em DB25 Modules have been connected to the
host adapter. The only set up required on the Xem host adapter is to set the I/O
port address to 124H-127H using DIP switch DS1
Address
124H-127H
666/HE/43100/000
TC12 Installation, Commissioning & Maintenance Handbook
SW10 SW11
OFF OFF
ON OFF
OFF ON
OFF ON
SW2 SW3 SW4
OFF ON OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF ON
SW1 SW2 SW3
OFF ON ON
Page 17
Address
0x100
0x120
0x200
0x220
SW5 SW6 SW7
OFF OFF OFF
OFF ON OFF
OFF OFF OFF
OFF OFF OFF
SW4
ON
SW8 Interrupt
OFF IRQ5
OFF IRQ11
ON IRQ15
OFF IRQ7
Issue 10