Siemens TC12 Installation, Commissioning And Maintenance Handbook page 117

3.3.3.38 Phase type for current sensor (KPT) L
KPT {sensor number: 1 - 23} = {phase type no.: 0 - 255}
Comment:
Monitorable lamp/phase types
Reserved
Intersection Vehicle (IV)
Pelican Vehicle (PV)
Intersection Pedestrian (IP)
Pelican Pedestrian (PP)
Wait Indicator 40 Watt (W4)
Wait Indicator 60 Watt (W6)
Regulatory Sign (RS)
Switched Sign - Bulb type (SB)
Switched Sign - Tube type (ST)
Pelican Pedestrian + 60 W Wait (PPW)
Pelican Stream + 60 W Wait (PS)
Intersection Pedestrian + 60 W Wait (IPW)
Intersection Pedestrian Stream (IPS)
Reserved
Export Pedestrian with flashing Red (XP1)
Export Vehicle with flashing Green (XV1)
Export Vehicle Filter - flashing Amber Ball (XV2)
Export Vehicle - flashing Amber signal group
(XV3)
Pelican Pedestrian + 40 W Wait (PP4)
Pelican Stream + 40 W Wait (PS4)
Intersection Pedestrian + 40 W (IP4)
Intersection Stream + 40 W Wait (IS4)
Sensor Unused - No type defined
3.3.3.39 Mains States Input Sense (KIS) L
KIS{0 - 3} = {00000000 - 11111111} (0)
Comment:
3.3.3.40 Confirmation and Learn Count (KLC)
KLC={4 - 1500} (12)
Comment:
666/HE/43100/000
TC12 Installation, Commissioning & Maintenance Handbook
To specify the lamp or phase type for a current sensor as defined in
the table below. See GLD command for further information on how
lamp faults are reported.
Enables the sense of the signals used to indicate lamp mains
states to be inverted for any input line. This would be required if the
controller provided closed contacts for active Green confirm
outputs. Usage is similar to the GIS command.
To change number of readings required to confirm a failure or
replacement, or learn a new characteristic.
Page 107
Type Reported Fail
no. Colours
0
1 R, A, G
2 R, A, G
3 Rm, Gm
4 Rm, Gm
5 Wt
6 Wt
7 S
8 S
9 S
10 Rm, Gm, Wt
11 R, A, G, Rm, Gm, Wt
12 Rm, Gm, Wt
13 R, A, G, Rm, Gm, Wt
14
15 Rm, Gm
16 R, A, G
17 Fl.B
18 R, A, G, FL.A
19 Rm, Gm, Wt
20 R, A, G, Rm, Gm, Wt
21 Rm, Gm, Wt
22 R, A, G, Rm, Gm, Wt
255
Issue 10