Appletalk; Autonet - Lanier LD225 Network Manual

Monitoring and Configuring the Printer
❖ Access control initialization
msh> access flush
• Use the "flush" command to re-
store the default settings so that
all access ranges become "0.0.0.0".
Note
❒ The access range restricts computers
from use of the machine by IP ad-
dress. If you do not need to restrict
printing, make the setting "0.0.0.0".
❒ Valid ranges must be from lower
(start address) to higher (end ad-
dress).
4
❒ Up to five access ranges can be
specified. The entry is invalid if the
target number is omitted.
❒ You cannot access Web Image
Monitor and diprint from a re-
stricted IP address.

appletalk

Use the "appletalk" command to view
and configure Appletalk parameters.
❖ View settings
msh> appletalk
• [2] means "active" and [0]
means "inactive".
• The default is [2].
❖ Changing PAP timeout configuration
msh> appletalk ptimeout
value > 0
• Timeout value becomes effective.
msh> appletalk ptimeout
value = 0
• Timeout value becomes ineffec-
tive.

autonet

Use the "autonet" command to con-
figure AutoNet parameters.
88
❖ View settings
The following command displays
the current AutoNet settings:
msh> autonet
❖ Configuration
You can configure AutoNet set-
tings.
msh> autonet {on|off}
• {on} means "active" and {off}
means "inactive".
❖ Current interface priority configura-
tion display
msh> autonet priority
❖ Interface priority configuration
m s h > a u t o n e t p r i o r i t y
"interface_name"
• You can give interface's AutoNet
parameter priority.
• Priority settings are available
when multiple interfaces are in-
stalled.
• ip1394 can be specified only
when the IEEE 1394 interface is
installed.
• wlan can be specified only when
the IEEE 802.11b interface is in-
stalled.
Interface name Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface
Note
❒ If an interface is not selected, the
current interface connection set-
tings remain in effect.
Reference
For details about AutoNet, refer to
autonet parameters.