Setting Up As A Print Server (Netware 4.X, 5 / 5.1, 6 / 6.5) - Lanier LD225 Network Manual

Using a Printer Server
Setting Up as a Print Server
(NetWare 4.x, 5 / 5.1, 6 / 6.5)
Follow the procedure below to con-
nect the machine as a print server us-
ing NetWare 4.x, NetWare 5 / 5.1, or
NetWare 6 / 6.5.
If TCP/IP and IP address is set, con-
figure using Web Image Monitor.
3
If IPX is set, configure using NIB Set-
up Tool.
Important
❒ When using the printer as a print
server in NetWare 4.x, NetWare 5
/ 5.1, or NetWare 6 / 6.5, set it to
the NDS mode.
❒ When using NetWare 5 / 5.1 or Net-
Ware 6 / 6.5, set the printer as a print
server.
Setting up using NIB Setup Tool (TCP/IP)
A
Log on to the file server as an ad-
ministrator or administrator
equivalent.
B
Start NIB Setup Tool from the
[Start] menu.
C
Click [Wizard], and then click [OK].
D
Select the printer you want to con-
figure, and then click [Finish ].
A dialog box prompting you to
perform the remaining configura-
tion tasks in the Web browser ap-
pears. Click [OK], and then wait
until Web Image Monitor starts au-
tomatically.
E
A dialog box for entering the [User
Name] and [Password] appears.
Enter the user name and pass-
word, and then click [OK].
56
Note
❒ For details about the password,
consult your network adminis-
trator.
F
Click [Configuration] in the left ar-
ea, click [Network], and then click
[NetWare].
Note
❒ For details , see p.53 "Setting Up
as a Print Server (NetWare
3.x)".
G
Confirm the settings, and then
click [Apply].
Configuration is now complete.
Wait several minutes before re-
starting Web Image Monitor.
Setting up using NIB Setup Tool (IPX)
A
Log on to the file server as an ad-
ministrator or administrator
equivalent.
B
Start NIB Setup Tool on the [Start]
menu.
C
Click [Wizard], and then click [OK].
D
Select the printer you want to con-
figure.
E
Enter the printer name in the [De-
vice Name:] box and a comment in
the [Comment] box, and then click
[Next >].
F
Select the [NetWare] check box,
and then click [Next >].
G
Click [NDS mode], enter the file
server name in the [File Server
Name:] box, the NDS tree name in
the [NDS Tree] box, and the context
in the [NDS Context:] box, and then
click [Next >].