Route - Lanier LD225 Network Manual

Monitoring and Configuring the Printer
• ipp
msh> rendezvous ipp [0–99]
You can specify the order of priority
for "diprint", "1pr", and "ipp". Small-
er numbers indicate higher priority.
❖ IP TTL setting
msh> rendezvous ipttl {1-
255}
You can specify the IP TTL (the
number of routers a packet can
pass through).
Note
❒ The default is 255.
4
❖ Resetting the computer name and lo-
cation information
You can reset the computer name
and location information.
m s h > r e n d e z v o u s c l e a r
{cname | location}
• cname
Reset the computer name. The
default computer name will be
displayed when the computer is
restarted.
• location
Reset the location information.
The previous location informa-
tion will be deleted.
❖ Interface configuration
msh> rendezvous linklocal
"interface_name"
• If many types of interface are in-
stalled, configure the interface
that communicates with linklo-
cal address.
• If you do not specify an inter-
face, the Ethernet interface is
automatically selected.
• ip1394 can be specified only when
the IEEE 1394 interface is installed.
• wlan can be specified only
when the IEEE 802.11b interface
is installed.
96
Interface Interface configured
ether Ethernet interface
ip1394 IEEE 1394 interface
wlan IEEE 802.11b interface

route

Use the "route" command to control
the routing table.
❖ All route information display
msh> route
❖ Specified route information display
msh> route "destination"
• Specify the IP address to desti-
nation.
❖ Enabling/disabling Specified Destina-
tion
msh> route active {host|net}
"destination" {on | off}
• You can turn the specified desti-
nation on or off. Host becomes
the default setting.
❖ Adding Routing Table
msh> route add {host|net}
"destination" "gateway"
• Adds a host or network route to
"destination", and a gateway ad-
dress to "gateway" in the table.
• Specify the IP address to desti-
nation and gateway.
• Host becomes the default setting.
❖ Setting Default Gateway
msh> route add default
"gateway"
❖ Deleting Specified destination from
Routing Table
msh> route delete {host|
net} "destination"