Connecting To The Ethernet Interface; Connecting To The Ieee 1394 Interface - Lanier LD225 Network Manual

Hide thumbs Also See for LD225:
Table of Contents

Advertisement

Connecting and Setting Up
Connecting to the Ethernet
Interface
The network interface board supports
10BASE-T or 100BASE-TX connec-
tions.
2
Important
❒ Before making the connection, touch
the metallic part to ground yourself.
A
Turn off the main power switch.
Important
❒ Make sure the main power is off.
See "Turning On the Power",
General Settings Guide.
B
Connect the Ethernet interface cable
to the 10BASE-T/100BASE-TX port.
C
Turn on the main power switch.
1.
Indicator (green)
Remains green when the machine is
properly connected to the network.
2.
Indicator (yellow)
Turns yellow when 100 BASE-TX is
operating. Turns off when 10 BASE-T
is operating.
10
Connecting to the IEEE 1394
Interface
Important
❒ Before making the connection, touch
the metallic part to ground yourself.
Note
❒ Use the interface cable supplied
with the optional IEEE 1394 inter-
face board.
❒ Make sure the interface cable is not
looped.
A
Turn off the main power switch.
Important
❒ Make sure the main power is off.
See "Turning On the Power",
General Settings Guide.
B
Connect the IEEE 1394 interface
cable to the IEEE 1394 ports.
AJL019S
Note
❒ Two interface ports are available
for connecting the IEEE 1394 in-
ZZZ023S
terface cable. Either is suitable.
❒ If you have an interface cable
with a ferrite core, connect the
end nearest to the ferrite core to
the machine.
❒ The position of the port differ
depending on the machine type.
C
Turn on the main power switch.
AJO005S

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ld235Ld2308030Ld24580358045 ... Show all

Table of Contents