Lanier LD225 Network Manual page 106

Monitoring and Configuring the Printer
❖ Deleting community name
msh> snmp "number" clear
name
❖ Access type configuration
msh> snmp "number" type
"access_type"
Access type Type of access permission
no
read
write
trap
4
❖ Protocol configuration
msh> snmp {ip | ipx} {on |
off}
• Use the following command to
set protocols "active" or "inac-
tive": If you set a protocol "inac-
tive", all access settings for that
protocol are disabled.
• Specify "ip" for TCP/IP, or "ipx"
for IPX/SPX.
• {on} means "active" and {off}
means "inactive".
• IEEE 1394 interface is available
for TCP/IP only.
❖ Configuration of protocol for each
registration number
msh> snmp "number" active
{ip | ipx} {on | off}
• To change the protocol of access
settings, use the following com-
mand. However, if you have
disabled a protocol with the
above command, activating it
here has no effect.
❖ Access configuration
msh> snmp "number" {ip/ad-
dr | ipx} "address"
• You can configure a host address
according to the protocol used.
100
not accessible
read only
read and write
user is notified of trap messages
• The network interface board ac-
cepts requests only from hosts
that have addresses with access
types of "read-only" or "read-
write". Enter "0" to have network
interface board accept requests
from any host without requiring
a specific type of access.
• Enter a host address to deliver
"trap" access type information to.
• To specify TCP/IP, enter "ip"
followed by a space, and then
the IP address.
• To specify IPX/SPX, enter "ipx"
followed by a space, the IPX ad-
dress followed by a decimal,
and then the MAC address of
the network interface board.
❖ sysLocation configuration
msh> snmp location
❖ Deleting sysLocation
msh> snmp clear location
❖ sysContact setting
msh> snmp contact
❖ Deleting sysContact
msh> snmp clear contact
❖ SNMP V1V2 function configuration
msh> snmp v1v2 {on | off}
• Specify "on" to enable, and "off"
to disable.
❖ SNMP v3 function configuration
msh> snmp v3 {on | off}
• Specify "on" to enable, and "off"
to disable.
❖ SNMP TRAP configuration
msh> snmp trap {v1 | v2 |
v3} {on | off}
• Specify "on" to enable, and "off"
to disable.