Lanier LD225 Network Manual page 44

Connecting and Setting Up
❖ Communication Mode
Specifies the communication mode
of the wireless LAN.
• 802.11 Ad hoc
• Ad hoc
• Infrastructure
Note
2
❒ Default: 802.11 Ad hoc
❖ SSID Setting
Specifies SSID to distinguish the
access point in infrastructure
mode or 802.11 ad hoc mode.
Limitation
❒ The characters that can be used
are ASCII 0x20-0x7e (32 bytes).
Note
❒ Default: blank (ASSID)
❒ If blank is specified in 802.11b
ad hoc mode or ad hoc mode,
"ASSID" appears.
❖ Channel
Specifies a channel when you select
802.11b ad hoc mode or ad hoc mode.
Note
❒ Default: 11
❒ The following channels are available:
• Metric version: 1-14
• Inch version: 1-11
❖ WEP (Encryption) Setting
Specifies the encryption of the
IEEE 802.11b (wireless LAN). If
this is set to [Active], you must en-
ter the WEP key.
• WEP
• Active
• Inactive
• Encryption
10 alphanumeric characters
must be entered for 64 bit, 26
characters for 128 bit.
Note
❒ Default: Inactive
38
❖ Wireless LAN Signal
Shows the radio wave conditions
of the access point connected in in-
frastructure mode.
Note
❒ Radio wave status is displayed
when you press [Wireless LAN
Signal].
❖ Transmission Speed
Specifies the communication speed
of the IEEE 802.11b (wireless LAN).
• Auto
• 11Mbps Fixed
• 5.5Mbps Fixed
• 2Mbps Fixed
• 1Mbps Fixed
Note
❒ Default: Auto
❖ Return to Defaults
You can return the IEEE 802.11b
(wireless LAN) settings to their de-
faults.
• No
• Yes
Print List
You can check items related to the
network in use.
Reference
For details about printing, see p.38
"Printing the Interface Settings".
Printing the Interface Settings
The configuration page shows the
current network settings and network
information.
A
Press the {User Tools/Counter/Inquiry}
key.
B
Press [System Settings].
C
Press [Interface Settings].