Table 57: ICMP Configuration Commands (continued)
Command
enable icmp useredirects
enable ip-option loose-source-route
enable ip-option record-route
enable ip-option record-timestamp
enable ip-option strict-source-route
enable ip-option use-router-alert
enable irdp {vlan <name>}
unconfig icmp
unconfig irdp
Routing Configuration Example
Figure 34 illustrates a switch that has two VLANs defined as follows:
• Finance
— Contains ports 2 and 4.
— IP address 192.207.35.1.
• Personnel
— Contains ports 3 and 5.
— IP address 192.207.36.1.
Summit 200 Series Switch Installation and User Guide
Description
Enables the modification of route table
information when an ICMP redirect message is
received. This option applies to the switch
when it is not configured for routing. The
default setting is disabled.
Enables the loose source route IP option.
Enables the record route IP option.
Enables the record timestamp IP option.
Enables the strict source route IP option.
Enables the switch to generate the router alert
IP option with routing protocol packets.
Enables the generation of ICMP router
advertisement messages on one or all VLANs.
The default setting is enabled.
Resets all ICMP settings to the default values.
Resets all router advertisement settings to the
default values.
Routing Configuration Example
201