Extreme Networks 200 Series Installation And User Manual page 225

Summit 200 series
Table of Contents

Advertisement

Table 66: OSPF Configuration Commands (continued)
Command
config ospf ase-summary delete <ipaddress>
<mask>
config ospf delete virtual-link <routerid>
<areaid>
config ospf delete vlan [<name> | all]
config ospf direct-filter [<access_profile> |
none]
config ospf lsa-batching-timer <timer_value>
config ospf metric-table <10M_cost>
<100M_cost> <1G_cost>
config ospf routerid [automatic | <routerid>]
config ospf spf-hold-time {<seconds>}
config ospf vlan <name> area <areaid>
Summit 200 Series Switch Installation and User Guide
Description
Deletes an aggregated OSPF external route.
Removes a virtual link.
Disables OSPF on one or all VLANs (router
interfaces).
Configures a route filter for direct routes. If
none is specified, all direct routes are exported
if ospf export direct is enabled.
Configures the OSPF LSA batching timer
value. The range is between 0 (disabled) and
600 seconds, using multiples of 5 seconds.
The LSAs added to the LSDB during the
interval are batched together for refresh or
timeout. The default setting is 30 seconds.
Configures the automatic interface costs for 10
Mbps, 100 Mbps, and 1 Gbps interfaces. The
default cost for 10 Mbps is 10, for 100 Mbps is
5, and for 4 Gbps is 1.
Configures the OSPF router ID. If automatic is
specified, the switch uses the largest IP
interface address as the OSPF router ID. The
default setting is automatic.
Configures the minimum number of seconds
between Shortest Path First (SPF)
recalculations. The default setting is 3 seconds.
Changes the area ID of an OSPF interface
(VLAN).
Configuring OSPF
223

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Summit 200-24Summit 200-48

Table of Contents