Setting The System Recovery Level; Logging - Extreme Networks 200 Series Installation And User Manual

Table 47: Port Monitoring Display Keys (continued)
Key(s)
[Space]

Setting the System Recovery Level

You can configure the system to automatically reboot after a software task exception, using the
following command:
config sys-recovery-level [none | critical | all]
where:
none
critical
all
The default setting is
NOTE
Extreme Networks recommends that you set the system recovery level to
ExtremeWare to log an error to the syslog and automatically reboot the system after a critical exception.

Logging

The switch log tracks all configuration and fault information pertaining to the device. Each entry in the
log contains the following information:
• Timestamp—The timestamp records the month and day of the event, along with the time (hours,
minutes, and seconds) in the form HH:MM:SS. If the event was caused by a user, the user name is
also provided.
• Fault level—Table 48 describes the three levels of importance that the system can assign to a fault.
Table 48: Fault Levels Assigned by the Switch
Level
Critical
Warning
Summit 200 Series Switch Installation and User Guide
Description
Cycles through the following screens:
• Packets per second
• Bytes per second
• Percentage of bandwidth
Available using the show port utilization command only.
Configures the level to recovery without a system reboot.
Configures ExtremeWare to log an error into the syslog and
automatically reboot the system after a critical exception.
Configures ExtremeWare to log an error into the syslog and
automatically reboot the system after any exception.
.
none
Description
A desired switch function is inoperable. The switch may need to be reset.
A noncritical error that may lead to a function failure.
Setting the System Recovery Level
. This allows
critical
175