Extreme Networks 200 Series Installation And User Manual page 136

Access Policies
Table 33: Routing Access Policy Configuration Commands (continued)
Command
config ospf direct-filter [<access_profile> |
none]
config rip vlan [<name> | all ] export-filter
[<access-profile> | none]
config rip vlan [<name> | all] import-filter
[<access_profile> | none]
config rip vlan [<name> | all] trusted-gateway
[<access_profile> | none]
create access-profile <access_profile> type
[ipaddress]
delete access-profile <access_profile>
show access-profile <access_profile>
134
Description
Configures the router to use the access policy to
limit the routes that are advertised into OSPF for
the switch as a whole for switches configured to
support direct route re-distribution into OSPF.
Configures RIP to suppress certain routes when
performing route advertisements.
Configures RIP to ignore certain routes received
from its neighbor.
Configures RIP to use the access list to
determine which RIP neighbor to receive (or
reject) the routes.
Creates an access profile. Once the access
profile is created, one or more addresses can be
added to it, and the profile can be used to control
a specific routing protocol.
Specify the following:
• ipaddress—A list of IP address and mask
pairs.
Deletes an access profile.
Displays access-profile related information for the
switch.
Summit 200 Series Switch Installation and User Guide