Extremeware Is The Full-Featured Software Operating System That Is Designed To Run On The Summit - Extreme Networks 200 Series Installation And User Manual

IP Unicast Routing
Table 57: ICMP Configuration Commands (continued)
Command
disable icmp parameter-problem {vlan <name>} Disables the generation of ICMP messages for
disable ip-option loose-source-route
disable ip-option record-route
disable ip-option record-timestamp
disable ip-option strict-source-route
disable ip-option use-router-alert
enable icmp address-mask {vlan <name>}
enable icmp parameter-problem {vlan <name>} Enables the generation of an ICMP
enable icmp port-unreachables {vlan <name>}
enable icmp redirects {vlan <name>}
enable icmp time-exceeded {vlan <name>}
enable icmp timestamp {vlan <name>}
enable icmp unreachables {vlan <name>}
200
Description
the parameter problem packet type.
Disables the loose source route IP option.
Disables the record route IP option.
Disables the record timestamp IP option.
Disables the strict source route IP option.
Disables the generation of the router alert IP
option.
Enables the generation of an ICMP
address-mask reply (type 18, code 0) when an
ICMP address mask request is received.The
default setting is enabled. If a VLAN is not
specified, the command applies to all IP
interfaces.
parameter-problem message (type 12) when
the switch cannot properly process the IP
header or IP option information. The default
setting is enabled. If a VLAN is not specified,
the command applies to all IP interfaces.
Enables the generation of ICMP port
unreachable messages (type 3, code 3) when
a TPC or UDP request is made to the switch,
and no application is waiting for the request, or
access policy denies the request. The default
setting is enabled. If a VLAN is not specified,
the command applies to all IP interfaces.
Enables the generation of an ICMP redirect
message (type 5) when a packet must be
forwarded out on the ingress port. The default
setting is enabled. If a VLAN is not specified,
the command applies to all IP interfaces.
Enables the generation of an ICMP time
exceeded message (type 11) when the TTL
field expires during forwarding. IP multicast
packets do not trigger ICMP time exceeded
messages. The default setting is enabled. If a
VLAN is not specified, the command applies to
all IP interfaces.
Enables the generation of an ICMP timestamp
response (type 14, code 0) when an ICMP
timestamp request is received. The default
setting is enabled. If a VLAN is not specified,
the command applies to all IP interfaces.
Enables the generation of ICMP network
unreachable messages (type 3, code 0), and
host unreachable messages (type 3, code 1)
when a packet cannot be forwarded to the
destination because of unreachable route or
host. ICMP packet processing on one or all
VLANs. The default setting is enabled. If a
VLAN is not specified, the command applies to
all IP interfaces.
Summit 200 Series Switch Installation and User Guide