Extreme Networks 200 Series Installation And User Manual page 224

Interior Gateway Routing Protocols
Table 66: OSPF Configuration Commands (continued)
Command
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid> <areaid>] timer
<retransmission_interval>
<transmission_delay> <hello_interval>
<dead_interval>
config ospf add virtual-link <routerid> <areaid>
config ospf add vlan <name> area <areaid>
{passive}
config ospf area <areaid> add range
<ipaddress> <mask> [advertise | noadvertise]
[type 3 | type 7]
config ospf area <areaid> delete range
<ipaddress> <mask>
config ospf area <areaid> normal
config ospf area <areaid> nssa [summary |
nosummary] stub-default-cost <cost>
{translate}
config ospf area <areaid> stub [summary |
nosummary] stub-default-cost <cost>
config ospf asbr-filter [<access_profile> | none] Configures a route filter for non-OSPF routes
config ospf ase-limit <number> {timeout
<seconds>}
config ospf ase-summary add <ipaddress>
<mask> cost <cost> {<tag_number>}
222
Description
Configures the timers for one interface or all
interfaces in the same OSPF area. The
following default, minimum, and maximum
values (in seconds) are used:
• retransmission_interval
Default: 5
Minimum: 0
Maximum: 3,600
• transmission_delay
Default: 1
Minimum: 0
Maximum: 3,600
• hello _interval
Default: 10
Minimum: 1
Maximum: 65,535
• dead_interval
Default: 40
Minimum: 1
Maximum: 2,147,483,647
Adds a virtual link to another ABR. Specify the
following:
• routerid—Far-end router interface
number.
• areaid—Transit area used for connecting
the two end-points.
Enables OSPF on one or all VLANs (router
interfaces). The <areaid> specifies the area
to which the VLAN is assigned. The passive
parameter indicates that the interface does not
send or receive OSPF packets.
Configures a range of IP addresses in an
OSPF area. If advertised, the range is exported
as a single LSA by the ABR.
Deletes a range of IP addresses in an OSPF
area.
Configures an OSFP area as a normal area.
The default setting is normal.
Configures an OSPF area as a NSSA.
Configures an OSPF area as a stub area.
exported into OSPF. If none is specified, no
RIP and static routes are filtered.
Configures OSPF database overflow.
Configures an aggregated OSPF external route
using the IP addresses specified.
Summit 200 Series Switch Installation and User Guide